LEDE/Openwrt 挂载USB无线网卡当AP

由于mt7621方案中mt7603e的2.4G lede驱动非常不稳定,导致我买的newifi d1、zbt wg3526、极路由4(HC5962)刷机后的2.4G基本都成了摆设。没办法只能通过挂载USB无线网卡当AP。
测试的USB网卡有:
X东购买tplink tl-wn725n v2.0 rtl8188eu (0x0bda:0x8179)安装驱动后直接无法启动路由器。。。跟作者发了邮件,回复说不支持。
X宝购买RT3070 杂牌网卡,安装驱动后直接无法开启ap模式,只能使用client模式。。。网上查询据说是最新的几版的驱动有问题,op老版本据说没问题,未测试。
X东购买磊科(netcore)NW362,rtl8192cu,安装驱动后完美ap模式。
以前买的tplink tl-wn821n v2.0,ar9170,安装kmod-carl9170驱动后,完美ap模式。

《LEDE/Openwrt 挂载USB无线网卡当AP》有6个想法

  1. 我的glinet挂卡3070不稳定,需要反复点wwam连接接口才能连接,还要看运气,怎么回事?

  2. 我也是被这个问题困扰了,
    https://blog.csdn.net/sy373466062/article/details/54866313
    提到过使用iw 命令可以看见能不能支持

    iw list
    ———–usb 8187——–
    Wiphy phy0
    max # scan SSIDs: 4
    max scan IEs length: 2285 bytes
    Retry short limit: 7
    Retry long limit: 4
    Coverage class: 0 (up to 0m)
    Available Antennas: TX 0 RX 0
    Supported interface modes:
    * IBSS
    * managed
    * monitor
    Band 1:
    Frequencies:
    * 2412 MHz [1] (30.0 dBm)
    —————-板载 9280网卡
    Wiphy phy1
    max # scan SSIDs: 4
    max scan IEs length: 2257 bytes
    Retry short limit: 7
    Retry long limit: 4
    Coverage class: 0 (up to 0m)
    Device supports AP-side u-APSD.
    Device supports T-DLS.
    Available Antennas: TX 0x3 RX 0x3
    Configured Antennas: TX 0x3 RX 0x3
    Supported interface modes:
    * IBSS
    * managed
    * AP
    * AP/VLAN
    * WDS
    * monitor
    * mesh point
    * P2P-client
    * P2P-GO
    Band 1:
    Capabilities: 0x11ce
    HT20/HT40
    SM Power Save disabled
    RX HT40 SGI
    TX STBC
    RX STBC 1-stream
    Max AMSDU length: 3839 bytes
    DSSS/CCK HT40
    Maximum RX AMPDU length 65535 bytes (exponent: 0x003)
    Minimum RX AMPDU time spacing: 8 usec (0x06)
    HT TX/RX MCS rate indexes supported: 0-15
    Frequencies:
    * 2412 MHz [1] (30.0 dBm)

  3. 我也是被这个问题困扰了
    https://blog.csdn.net/sy373466062/article/details/54866313
    提到过使用iw 可以看见网卡支持模式
    ———板载 ar 9280 支持ap 模式—
    Wiphy phy1
    max # scan SSIDs: 4
    max scan IEs length: 2257 bytes
    Retry short limit: 7
    Retry long limit: 4
    Coverage class: 0 (up to 0m)
    Device supports AP-side u-APSD.
    Device supports T-DLS.
    Available Antennas: TX 0x3 RX 0x3
    Configured Antennas: TX 0x3 RX 0x3
    Supported interface modes:
    * IBSS
    * managed
    * AP
    * AP/VLAN
    * WDS
    * monitor
    * mesh point
    * P2P-client
    * P2P-GO
    Band 1:
    Capabilities: 0x11ce
    HT20/HT40
    SM Power Save disabled
    RX HT40 SGI
    TX STBC
    RX STBC 1-stream
    Max AMSDU length: 3839 bytes
    DSSS/CCK HT40
    Maximum RX AMPDU length 65535 bytes (exponent: 0x003)
    Minimum RX AMPDU time spacing: 8 usec (0x06)
    HT TX/RX MCS rate indexes supported: 0-15
    Frequencies:
    * 2412 MHz [1] (30.0 dBm)
    ————usb 8187 网卡 不支持ap模式———-
    Wiphy phy0
    max # scan SSIDs: 4
    max scan IEs length: 2285 bytes
    Retry short limit: 7
    Retry long limit: 4
    Coverage class: 0 (up to 0m)
    Available Antennas: TX 0 RX 0
    Supported interface modes:
    * IBSS
    * managed
    * monitor
    Band 1:
    Frequencies:
    * 2412 MHz [1] (30.0 dBm)

发表评论

电子邮件地址不会被公开。 必填项已用*标注